Until you're like, yeah

... to me to feel.

'Cause, you know, it does take time to f- I mean, first you have to design it, right? And then, you know, you have to build what's called work holding, so when it sits in the mill, you know, it has to, you know, sit a certain way every single time, and so you have to, you have to build out, um, ways to do that, um, so that it sits perfectly every single time.

So that takes a little bit of time.

And then, you know, once you get to that point, you cut the putter, and, you know, it usually comes out pretty good on the first time, and then, but, you know, you might make some adjustments.

Like, you know, uh, my, my third model, I, it looked a little too, I wanted it to be small, but it looked a little too small when I first, when I built my first prototype.

And, uh, so you make adjustments.

... because I, they are light.