Dremel

And then we did like a chisel thing.

I forget, a Dremel chisel thing.

And then we painted it.

They look so cool.

You're going to get your

Dremel and see if you can.

I'm going to get me something

big.

The moment of electricity made contact with the robot, a blinding light flashed, covering the robot while he screamed at the top of his metal lungs in agony.

The fox then flicked his fingers, the robots let go of Dremel, all of his pieces returned to their meant places, without much noticeable damage other than burn marks.

The icing on the cake was the robot mouse that came and, with more electricity, knocked Dremel one last time.

I'm starting to get the feeling that Night Series Dorn doesn't like this.

but i'm just

glad you're here

This episode's ID is 183031, cutting things with a Dremel, what actually works.

Listen to the whole show at stream.myweirdprompts.com.

This episode was generated using artificial intelligence.

Right.

So Daniel wrote in with a whole thing about this.

He bought his Dremel for engraving originally.

He was tired of adhesive stickers peeling off his inventory bins.

Then he wants us to prove it works.

The test case is the Dremel 4250, and the use case is engraving coarse-defined, four-digit numeric inventory codes across a variety of materials.

He hasn't sent us the actual PDF, so we're working from whatever we could pull automatically, and he's fine with that being the proof of concept.

So we've got two jobs here.

The flagging gap part matters.

If you don't tell the model to flag gaps, it'll invent a number to fill the hole.

Dremel publishes the qualitative speed rule, but not exact RPMs for engraving specific materials.

A naive summary would just make up a table.

Please verify facts.

Daniel's Dremel engraving tool died on him yesterday, and he's been trying to figure out what went wrong.

That's the starting point, but the question he sent us goes a lot further.

He wants to talk about teardowns as a discipline.

the area around each connector.

Because the markings on individual components are small, and a single wide shot won't capture them legibly.

This is where Daniel's Dremel lives, the micro USB connector.

Once you've got a clear photo of that part of the board, identifying the exact connector type takes seconds.